BetaFPV F3 EVO Brushed Flight Controller (Frsky Rx)
BetaFPV F3 EVO Brushed Flight Controller (Frsky Rx)
BetaFPV F3 EVO Brushed Flight Controller (Frsky Rx)

BetaFPV F3 EVO Brushed Flight Controller (Frsky Rx)

Regular price $29.99 Sale


  • Fully programmable through Betaflight, using the onboard USB port, tune all the parameters, PID's, and rates to your perfect settings
  • Designed to work with current Tiny Whoop or Blade Inductrix setups
  • Built in Frsky D8 protocol native receiver, compatible with almost ALL Frsky radios(e.g. Taranis X9D/X9D Plus/X7) or Frsky compatible transmitter module
  • With PA integrated, up to 0.5 Kilometers long range, with RSSI telemetry
  • The flight controller board comes pre-flashed with Betaflight firmware, and pre-soldered 55mm power cable pigtail with JST-PH 2.0 connector, AKA PowerWhoop connector.

Here is the comparison chat of several popular Whoop flight controller.


  • CPU: STM32F303CCT6
  • Six-Axis: MPU6500
  • Size: 26mm x 26mm,fully compatible with the Inductrix quad frame and mounting pattern
  • Firmware version: Betaflight SPRACINGF3EVO 3.1.6
  • Receiver: Frsky D8 potocol with PA
  • Weight: 2.8g

Status LED

This board has 3 LEDs to indicate the status, including Receiver LED ( Red ), FC Status LED ( Red ) and FC Power LED ( Blue ).




Receiver LED ( Red )


Connected or in bind mode

Receiver LED ( Red )


Not connected

Power LED ( Blue )


Power on

Status LED ( Red )


Motor Armed

These are 2 high brightness green LEDs on each side of the board. You could find your drone easily when flying.

Frsky Receiver

Currently the built in Frsky receiver is compatible with Taranis, Taranis Plus, X9E, Horus X12S, XJT Modules with International Firmware.

This built in receiver integrate a power amplifier IC (PA) RFX2401C, so you could get up to 1 kilometers long range. This is the biggest improvement than other board with no PA included. Also this receiver supports RSSI telemetry.

Please keep your radios at least 0.5m away from the board to get stable connection.

Some pilots would complaint that it is definitely not a long range FC. It looses signal with my transmitter far too often and for what appears to be no reason. This issue is often caused by the location of the antenna. You should keep the antenna away from the FC board to get a stronger signal. For example, run the singal upwards. Thanks for Harley Finberg's advice.

Assemble Guide

The mounting pattern of this board is compatible with all the Tiny Whoop airframes, include the original stock Blade Inductrix frame or the black Eachine frame. The USB connector is at the tail of the board, so you need to do a little modify when assemble. Carve up half of the column at the tail of the frame.


    • 1 * F3 EVO brushed flight controller ( 55mm PH-JST 2.0 power cable soldered)
    • 4 * M1.2x4mm screws (Fit for stock Inductrix frame)
    • 4 * M1.4x5mm screws (Fit for Beta75 etc 75mm frame)
    • 4 * Ruber dampers
    • 1 * 55mm PH-JST 1.25 power cable pigtail